Address Table (Addr Table) - ADTRAN Express 5200 User Manual

Chapter 6. DTE Port Configuration
Setting the IP A
DLCI to a value not used by the attached frame relay device
disables this feature.
IP Address
Enter the Express 5200 IP A
IP traffic has its own unique IP A
for Configuring IP Address, Subnet Mask, and Management DLCI on
page 6-5 for more information.
Subnet Mask
Enter the subnet number assigned to the network formed by the
Express 5200 and the other FRAD/routers across the frame relay
network. See the section Guidelines for Configuring IP Address,
Subnet Mask, and Management DLCI on page 6-5 for more
information.
Management DLCI (MGMT DLCI)
Enter the management data link connection identifier. The
M
ANAGEMENT
DTE device and the Express 5200 to carry SNMP and TELNET
packets to/from the Express 5200 on the
Guidelines for Configuring IP Address, Subnet Mask, and Management
DLCI on page 6-5 for more information.

Address Table (ADDR TABLE)

DTE Port DLCI (DTE DLCI)
Enter the DTE P
mapping it to the corresponding N
translation is not required, set to the value of the corresponding
N
ETWORK
Network DLCI (NET DLCI)
Enter the network port DLCI into the protocol A
mapping it to the corresponding DTE P
should contain DLCI addresses obtained from the service provider.
Next (NEXT key on front panel)
Edit the next entry in the address table.
Previous (PREV key on front panel)
Edit the previous entry in the address table.
6-6
to 0.0.0.0 and setting the M
DDRESS
DDRESS
DLCI is a special DLCI used between the attached
DLCI into the protocol A
ORT
DLCI element.
Express 5200 User Manual
ANAGEMENT
. Each port capable of carrying
. See the section Guidelines
DDRESS
port. See the section
DTE
T
DDRESS
DLCI . If address
ETWORK
DDRESS
DLCI . This element
ORT
,
ABLE
T
,
ABLE
61202175L1-1