Table of Contents
Advertisement
Destination DLCI (DEST DLCI)
Enter the virtual circuit to be used when the network port is part of
the destination IP path. This selection is only applicable if the
corresponding D
Next (NEXT key on front panel)
Edit the next entry in the address table.
Previous (PREV key on front panel)
Edit the previous entry in the address table.
Add (ADD key on front panel)
Add a new entry to the address table.
Delete (DELETE key on front panel)
Delete the current entry in the address table.
Gateway IP Address (GW IP ADDRESS)
Enter the G
IP address is received, the Express 5200 sends it to the Gateway
(which is a router or another FRAD).
Gateway Destination Port (GW DEST PORT)
Enter the port from which the gateway can be reached.
Gateway DLCI (GW DLCI)
If the G
parameter identifies the virtual circuit used to reach the gateway.
Transmit ARP Packets (TX ARP)
This parameter enables the transmit portion of the network port
inverse ARP protocol. If enabled, inverse ARP messages are sent to
every DLCI assigned to the network port each ARP refresh time
period and inverse ARP responses are generated.
61202175L1-1
P
ESTINATION
IP A
ATEWAY
DDRESS
D
P
ATEWAY
ESTINATION
Express 5200 User Manual
Chapter 10. IP Routing
is set for N
ORT
ETWORK
. If an IP packet with an unknown
is set to N
ORT
ETWORK
P
.
ORT
, this
10-5
Advertisement
Table of Contents
