Table of Contents
Advertisement
Chapter 5. Configuration Overview
When configuring DTE P
selection determines which parameters will be available for the P
L
AYER
The Express 5200 contains a default set of configuration options
stored in read-only memory. The unit is shipped from the factory
with this profile loaded into the current (nonvolatile configuration)
memory. If this profile matches requirements for the system, then
no additional configuration is required to put the unit into service.
If the profile does not match system requirements, it can be
modified.
For detailed information on configuration see the chapters DTE Port
Configuration on page 6-1, Voice Interface Configuration on page 7-1, Net-
work Port Configuration on page 8-1, Dial Backup Configuration on page
9-1, IP Routing on page 10-1, and System Configuration on page 11-1.
.
5-2
1 or 2 , select the P
ORT
O
, P
O
PTIONS
ROTOCOL
Figure 5-1. VT 100 Configuration Menu (DBU card
Express 5200 User Manual
ROTOCOL
, and A
T
PTIONS
DDRESS
first. This
HYSICAL
.
ABLE
installed)
61202175L1-1
Advertisement
Table of Contents
