Table of Contents
Advertisement
Chapter 6. DTE Port Configuration
Slow Poll Ratio <N:1> (POLL RATIO)
Determine how often devices on the Slow Poll List are polled. This
list is automatically managed based on poll timeouts. Initially, all
controllers are on the Normal list. When a controller times out a
fixed number of times, it is moved to the Slow Poll list. A controller
remains on this list until it responds properly to a poll.
The number entered is the number of times controllers on the
Normal list are polled before controllers on the Slow Poll list are
polled. Enter 1 to disable this option.
Transmit Delay (TX DELAY)
Set the minimum time between transmission frames.
CTS Option
Set the Express 5200 CTS O
O
.
N
Data Format (FORMAT)
Set the D
non-return-to zero ( NRZ ) and non-return-to-zero inverted ( NRZI ).
Address Table (ADDR TABLE)
Poll Address (POLL ADDR)
Enter the address string used to poll data from the unit.
Select Address (SELECT ADR)
Enter the address string used to put the bisync device into a mode
where it can accept data.
LLC2 SSAP
Defines a point-to-point connection on the network. For each
bisync SDLC connection, the SSAP of one Express 5200 should
match the DSAP on the other Express 5200.
LLC2 DSAP
Define a point-to-point connection on the network. For each bisync
SDLC connection, the DSAP of one Express 5200 should match the
SSAP on the other Express 5200. See the section SNA/SDLC with
Local Spoofing on page 4-1 for a configuration example which
demonstrates the SSAP and DSAP arrangement.
6-16
PTION
F
used by your equipment. The choices are
ATA
ORMAT
Express 5200 User Manual
to F
RTS or to be F
OLLOW
61202175L1-1
ORCED
Advertisement
Table of Contents
