Address Table (Addr Table); Ppp Async Protocol - ADTRAN Express 5200 User Manual

Chapter 6. DTE Port Configuration
TD Clock Source (TD CLOCK SRC)
Set clock source to I
Transmit Idle Code (TX IDLE CODE)
Enable the Express 5200 to transmit F
Hardware Flow Control (HDW FLOW CTRL)
When enabled, the Express 5200 varies the transmit clock rate to
temporarily limit the transmit data rate to the Express 5200.

Address Table (ADDR TABLE)

IP Address
Enter the internet protocol (IP) address assigned to the
Express 5200 for the
Subnet Mask
Enter the subnet number assigned to the network formed by the
Express 5200 and the Peer PPP station.
Peer IP Address (PEER IP ADDR)
Enter the IP address of the attached PPP device.
Transmit RIP Packets (XMIT RIP)
Enable or disable the Express 5200's transmission of routing
information protocol (RIP) messages. RIP broadcasts occur in
60-second intervals, advertising network addresses to the Peer PPP
device. Routing tables are generated from these broadcasts.
Process Received RIP Packets (RIP PCKTS)
Enable or disable the Express 5200's reply to the request from the
Peer PPP device to issue RIP messages.

PPP Async Protocol

The PPP A
S
YNCHRONOUS
connected to an async device. Special control characters are used to
determine frame boundaries for the async channel. P
options are not available when the PPP A
enabled. See Figure 6-10 for the PPP A
6-22
or E
NTERNAL XTERNAL
port.
DTE
protocol functions the same as the PPP
SYNC
protocol except the port is in async format,
Express 5200 User Manual
.
or all O
.
LAGS NES
ROTOCOL
protocol is
SYNCHRONOUS
menu tree.
SYNCHRONOUS
61202175L1-1