Table of Contents
Advertisement
Bit Rate (BIT RATE)
Select the operating speed of the
The bit rate selections vary depending on the speed selections made for the
Network
card is required.
TD Clock Source (TD CLOCK SRC)
Set the clock source to I
Transmit Idle Code (TX IDLE CODE)
Enable the Express 5200 to transmit F
Hardware Flow Control (HDW FLOW CTRL)
When configured for the B
enabled. The Express 5200 uses commands within the B
protocol to temporarily disable transmit data to the Express 5200.
Protocol Options (PROTOCOL OPTS)
Line Type (LINE)
Select a P
Emulation Type (EMUL TYPE)
For multi-point configurations, this entry defines P
S
ECONDARY
to S
controller to P
Translation Code (TRANSLAT CODE)
Define the character set and error checking algorithm to use. The
choices are EBCDIC CRC16 , ASCII CRC16 , ASCII O
VRC/LRC , and ASCII E
Poll/Response Timeout (TIMEOUT)
For multi-point configurations, set the amount of time the
Express 5200 waits for a poll response before issuing another poll.
Disconnect Threshold (THRESHOLD)
For multi-point configurations, set the maximum number of
response timeouts allowed before a session is terminated.
61202175L1-1
port. Also, for rates higher than 56/64 kbps, the External DCE
NTERNAL
-T
-P
, M
OINT
O
OINT
emulation. Set the Express 5200 connected to the host
and the Express 5200 connected to the 2780/3780
ECONDARY
.
RIMARY
VEN
Express 5200 User Manual
Chapter 6. DTE Port Configuration
interface.
DTE
or E
.
XTERNAL
or all O
LAGS
protocol, this parameter is always
ISYNC
-P
, or T
ULTI
OINT
RANSPARENT
P
VRC/LRC .
ARITY
.
NES
ISYNC
line type.
or
RIMARY
P
DD
ARITY
6-15
Advertisement
Table of Contents
