Table of Contents
Advertisement
Chapter 11. System Configuration
1 CONFIG
SYSTEM
Change Password
Enter a new password of nine digits or less. The default password
is
adtran
Read Community (RD COMMUNITY)
Enter the authentication strings used for SNMP management.
Match the Express 5200 to the SNMP manager for read privileges.
If you are using the front panel, see the section Entering Letters
Using the Front Panel on page 11-3 for instructions.
Write Community (WR COMMUNITY)
Enter the authentication strings used for SNMP management.
Match the Express 5200 to the SNMP manager for write privileges.
If you are using the front panel, see the section Entering Letters
Using the Front Panel on page 11-3 for instructions.
Trap Mgr Options (TRAP MGR OPTS)
Trap Manager DLCI (TRAP DLCI)
If the T
identifies the virtual circuit used for all traps generated by the
Express 5200.
11-2
1 RD COMMUNITY
2 WR COMMUNITY
3 TRAP MGR OPTS
4 SUPPORT FRAG
5 SYSTEM TIME
6 SYSTEM DATE
Figure 11-2. System Configuration Front Panel Menu
. This selection is only available in the VT 100 interface.
M
P
RAP
ANAGER
ORT
Express 5200 User Manual
1 TRAP DLCI
2 TRAP IP
3 TRAP PORT
NO
YES
is set for N
, this parameter
ETWORK
NONE
DTE PORT 1
DTE PORT 2
NETWORK PORT
61202175L1-1
Advertisement
Table of Contents
