Transparent Bop Protocol (Trans Bop) - ADTRAN Express 5200 User Manual

host's group address. Set this entry to 0 to disable group polling for
the
LLC2 SSAP
Defines a point-to-point connection on the network. For an SDLC
connection, the SSAP of one Express 5200 should match the DSAP
on the other Express 5200. The value of this parameter must be in
increments of four beginning with 04.
LLC2 DSAP
Defines a point-to-point connection on the network. For an SDLC
connection, the DSAP of one Express 5200 should match the SSAP
on the other Express 5200. The value of this parameter must be in
increments of four beginning with 04. See the section SNA/SDLC
with Local Spoofing on page 4-1 for a configuration example which
demonstrates the SSAP and DSAP arrangement.
Outgoing DLCI (OUT DLCI)
Enter the DLCI address that identifies the virtual circuit used to
make the SDLC connection.
Next Entry (NEXT on front panel)
Edit the next entry in the address table.
Previous Entry (PREV on front panel)
Edit the previous entry in the address table.
Add (ADD on front panel)
Add a new entry to the address table
Delete (DELETE on front panel)
Delete the current entry in the address table.

Transparent BOP Protocol (TRANS BOP)

T
RANSPARENT
HDLC-like protocol as input. This setting allows the Express 5200
to connect to devices even if the Express 5200 does not understand
their protocol's addressing and controlling techniques. The
Express 5200 becomes transparent to the data link layer protocol
61202175L1-1
port.
DTE
BOP is a synchronous mode which can accept any
Express 5200 User Manual
Chapter 6. DTE Port Configuration
6-11