Cleaning The Paper Guide Before The Corona Wire - QMS DeskLaser 1600 User Manual

Table of Contents

Use the cleaning brush supplied with the printer. This L-shaped tool has

two cleaning pads: one for the corona wire and the other for the

precharger wire inside the print unit. Use the pad on the shorter

branch.

After you have cleaned the printer, install the print unit and close the

upper door.

Cleaning the Paper Guide before the Corona Wire

Perform this procedure when printouts show small spots of toner

smudging especially near the top edge of paper.

QMS DeskLaser 1600 User Manual

Remove the print unit and

store it in a dark, level, steady

place. Be careful not to

damage the green drum

surface. Using the tool as

shown in this figure, clean the

corona wire. Fit the

positioning cut onto the wire

housing frame and gently

move the tool left and right

two or three times along the

length of the wire to remove

any dirt or other substance.

Be careful not to break or

otherwise damage the wire.

Open the upper door and

remove the print unit. Be

careful not to damage the

green drum surface. Look for

dust on the paper guide

before the corona wire. Use a

clean, lint free cloth to gently

remove any dust from the

entire surface of the paper

guide.

4-11

Table of Contents