Clearing The Buffer And Reinitializing The Printer; Printing A Status Report - QMS DeskLaser 1600 User Manual

QMS DeskLaser 1600 User Manual

Clearing the Buffer and Reinitializing the Printer (

Pressing and holding down
print buffer and tells the printer to initialize itself. You might use this
function if you cancel a print job in the middle and want to clear the
printer and start over. In this case, permanently downloaded fonts are
removed by the initialization process. You must download the fonts again.

Printing a Status Report (

The status report function prints a page that summarizes printer option
settings and shows samples of resident fonts.
To print a status report, follow these steps:
1. Make sure that the message display indicates
ONLINE and DATA indicators off.
2. Press the button for five or more seconds.
SELF TEST
The message changes to
PAGE CONFIG, START
button, the printer prints a status report. After printing, the
ENTER
printer returns to the original state.
Notice:
The status report is for either the PCL emulation or the PS
emulation depending on the emulation you used for printing the last
document; however, the status report is for the PS emulation if it is
printed immediately after the printer is turned on. To clearly select
the report, use the test menu in setup mode.
for five or more seconds clears the
RESET
)
SELF TEST
READY
. After pressing the
)
RESET
with the
2-6