Network Transmission Setting Between Ecdis And Radar; Forwarding Distance - Furuno FAR-3210 Installation Manual

3.7 Network Transmission Setting Between ECDIS
and Radar
Connect the ECDIS and FAR-3xx0 series radar with the LAN cable to show the radar
echo and TT symbols on the ECDIS chart display, and show the ECDIS route and user
chart symbols on the radar display.
1. Press the MENU key five times while holding down the [1 HL OFF] key.
2. Select [9 RADAR INSTALLATION][4 TT PRESET][1 TTM/TTD PREFER-
ENCE] and then select [TRUE].
3. On the ECDIS, open the [Common Installation Setting] menu.
4. Open the [Own Ship Setting] menu on the ECDIS to select [Radar Antenna] on
the menu bar.
5. For one antenna unit, check [RAS001]. For two antenna units, check[ RAS001]
and [RAS002].
3.8

Forwarding Distance

Set the forwarding distance* as follows. The configuration can be copied to other units
connected to the network after saving the configuration.
*: The distance the ship travels straight after the steering control.
1. In the chart mode, press Ctrl,
Shift and t keys simultane-
ously on the control unit or
keyboard. A dialog box for
password input appears.
2. Enter the password and click the [OK] button.
Note: The edit mode remains enabled until you press Ctrl, Shift and t keys simul-
taneously or reboot the unit.
3. Click [MENU] in the chart mode to open the menu.
4. Click [Navigation Parameter] to show the [Navigation Parameter] setting window.
5. Enter [SPD kn] (ship speed), [Radius NM] (turning radius) and [FWD DIST NM]
(forwarding distance*).
3. SETTINGS AND ADJUSTMENTS
3-13