Furuno FAR-3210 Installation Manual page 27

Lifting fixture Lifting fixture
Shackle Shackle
(left, right) (left, right)
How to remove the lifting fixture
The lifting fixtures are attached to the base of the chassis and must be removed after hoisting the antenna
unit. The two lifting fixtures are fixed together with a scanner bolt at the factory, as shown in the figure below.
Scanner bolts
1 Loosen two scanner bolts.
How to fasten the Antenna Unit to the mounting platform
1. Construct a suitable mounting platform referring to the outline drawing at the end
of this manual.
Note: The mounting platform must be flat, level and firmly secured.
• The diameter of the mast for fixing the Antenna Unit platform must be over 180
mm.
• The thickness of the Antenna Unit platform must be over 12 mm.
• The reinforcement rib must be installed diagonally.
Mounting
platform
2. Referring to the outline drawing at the back of this manual, drill four mounting
holes (15 mm) in the mounting platform.
Belt sling Belt sling
(ø20) (ø20)
Lifting fixtures Lifting fixtures
2 Separate the lifting fixtures to remove them.
Tighten the scanner bolts (torque: 10 N•m).
Bottom of platform
The reinforcement
ribs must be
installed diagonally.
Over 12 mm
Thickness: Over 6 mm Thickness: Over 6 mm
1. INSTALLATION
Bow side UP
Radiator Radiator
bracket bracket
Note: Pass the belt sling
around the stern side of
the radiator bracket.
Scanner bolts
Alignment position (four places)
Be careful not to
get welding splatter
on nuts, bolts, etc.
on the mounting
platform.
Diameter: Diameter:
Over 180 mm Over 180 mm
1-5