Furuno FAR-3210 Installation Manual page 130

3. SETTINGS AND ADJUSTMENTS
• [SELECT SENTENCE]: Select the sentence
that is output the TT target data.
[OFF]: For no output of the TT data.
[TTM]: For connected equipment which can re-
ceive the TTM sentence.
[TTD]: For connected equipment which can re-
ceive the TTD sentence.
[BOTH]: For connected equipment which can
receive both TTM and TTD sentences.
Note: This setting is valid for LAN connection
only. For serial connection, the output sentence
is determined on the [Common Installation Set-
ting] menu, this setting is invalid. See WEB
SETTING MANUAL (E32-01305) for details. For both LAN and serial connections,
set the baudrate to 38,400 bps.
• [TTM/TTD REFERENCE]: Set the output format for tracked target's bearing.
[REL] (Target bearing from own ship, degree relative, target course, degree rela-
tive), or [TRUE] (Target bearing, degree true, target course, degree true).
• [TTD VERSION]: For TTD sentence, select the required protocol version for the
connected equipment for TTD output ([0]: ver. 0 only, [1]: ver. 0 and ver. 1).
Note: If the connected equipment is FMD-3x00, select [1].
[2 NUMBER OF TT]
Set the number of targets that can be acquired, [100] or [MAX] (200). For FAR-2xx7
radar, select [100].
[3 MAX RANGE]
Select the maximum target tracking range, 24 or 32 nm.
[4 QV DISPLAY]
[OFF]: Normal picture,
[ON]: Quantized video. The normal picture is in effect whenever the power is turned
on regardless of this setting.
[5 QV ECHO LEVEL]
Set the detection level of echoes. The setting range is 1 to 31.
3-10