Sensor Adapters (Option) - Furuno FAR-3210 Installation Manual

2. WIRING
EXT BRILL
CTRL
RS-485
*: [DVI PWR SYNC] is the slide switch at the bottom rear of the monitor unit. Confirm
that this switch is set to [ON] (default setting). See Slide switch below for details.
Slide switch
Set the slide switch to "ON"
(default setting). This setting
automatically powers the mon-
itor unit on or off according to
the DVI signal input. The pow-
er switch of the monitor unit is
inoperative.
Note: The OFF position provides control of the monitor unit power with the power
switch of the monitor unit.
How to open the [INSTALLATION SETTING] menu
Turn off the monitor unit. While you hold the DISP key, press the BRILL key to turn on
the monitor unit. Keep the DISP key pressed until the [INSTALLATION SETTING]
menu appears.
Note: When the [DVI PWR SYNC] slide switch is ON, turn on the connected external
equipment while you press the DISP key to turn on the monitor unit.
2.10

Sensor Adapters (option)

A maximum of eight MC-3000S can be connected to a sensor network (for the redun-
dant connection: 16). The MC-3000S (serial input/output, IEC61162-2/1, 4ch) can
connect a maximum of 10 sensor adapters, using the MC1.5-W cables. The maximum
number of MC-3010A units is five.
When fabricating the MC1.5-W cables, use the lot terminal (ferrule type, supplied) to
maintain performance. Use the ferrule-type terminals (supplied) to connect the cables
to the terminals in the sensor adapters. This connection requires a crimping tool
(CRIMPFOX10S, option). For the relations between the connectors and rod terminals,
see page AP-2. Also, the stickers attached on the reverse side of the covers show the
detailed connections.
Vinyl sheath
Rod terminal (ferrule type):
After attaching the rod terminal, use the optional crimping tool CRIMPFOX 10S to crimp.
2-52
SERIAL BAUD COLOR
RATE CALIBRATION
4800bps
Slide switch
RGB
port
Ferrule-type lug
Core
AI 1.5-6 BK (BLK)
AI 0.34-6 TQ (BLU)
AI 0.75-6 GY (GREY)
L
AI 1-6 RD (RED)
AI 0.14-8 GY(GREY)
0.5 to 1 mm
KEY
LOCK
ON ON
ON (Default setting)
OFF
Length of "L"
6 mm
8 mm
Rod terminal (ferrule type):
The core must protrude 0.5 to 1 mm past
the rod terminal.
DVI PWR
SYNC*
ON
DVI
port