Furuno FAR-3210 Installation Manual page 71

TTYCYSLA-10 (for serial cable)
10 10
Outer sheath
DPYCY-1.5 (for the optional de-icer)
• Before beginning any work on the Antenna Unit, turn off the breaker for the de-icer
at the mains switchboard. (Turning off the display unit has no effect.)
• The de-icer activates when the temperature becomes 0 °C, and shuts down when
the temperature reaches 5 °C.
Wrap the spiral tubing near the crimp-on lugs.
10 10
Outer sheath
Microwave coaxial cable
See the FURUNO Installation Handbook (publication no. TIE-00160) for how to treat
this cable.
2.5.2 How to connect the cables for S-band radar (TR-DOWN)
Three cables are connected to the Antenna Unit: serial cable from the transceiver unit,
microwave coaxial cable and de-icer power cable (option). The procedure shows how
to connect all cables. Disregard the descriptions for the optional equipment if not ap-
plicable.
Note: Apply the supplied adhesive to the unused cable glands.
390 390
30 30
Drain wire Drain wire
Armor Inner sheath
Vinyl tape
30 30
Vinyl tape
Armor
Inner sheath
REAR REAR
200 200
6
Pass the heat shrink tubing (local supply)
onto the drain wire.
1310 1310
Spiral tubing
De-icer power cable
Microwave coaxial cable
Serial cable from the
transceiver unit
Antenna motor switch
2. WIRING
6
Crimp-on lug
(unit: mm)
6
Crimp-on lug
(unit: mm) (FV2-M4)
2-29