2: Enabling Control; 3: Sending Commands - Honeywell HON-CGW-MBB Installation And User Manual

CLSS Gateway Control Features
7.20.2 Enabling Control
CAUTION: UL LISTING
ENABLING CONTROL VOIDS THE UL LISTING OF THE CLSS GATEWAY.
CLSS gateway control is enabled through a web page-based configuration tool running
on the gateway. Enable control as follows:
1. Start the web browser on a computer that is in the same IP network as the CLSS
Gateway.
Note: Chrome is the recommended browser.
2. Enter the following URL in the browser:
https://192.168.10.190:9443/config/index.html
3. Do the following if any security warning is shown. Otherwise, go to step 4.
• Click the Advanced link below the error message.
• Agree to proceed.
4. In the Gateway Configuration Tool page, enter the password.
5. Go to Modbus Tools in Modbus Settings.
6. Enable or disable as needed in the control functionality.
7. Read the UL Void message shown, if it is enabled.
8. Click Save.
9. Wait until the CLSS Gateway shows the changes.
10.Check that the changes are correct.
7.20.3 Sending Commands
Send commands through the CLSS gateway by writing command values to the
appropriate holding registers. For detailed register mapping information refer to the
"Register Mapping"
command types for nodes, points, and zones.
Reset
Silence
Acknowledge
Disable
Enable
Activate
Deactivate
Disable
Enable
Activate *
Deactivate *
CLSS Gateway - Installation and Users' Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022
section. The following tables display the values representing all the
Table 7.5: Node Commands
Command Value
0x0001
0x0002
Table 7.6: Point Commands
Command Value
0x0100
0x0200
0x0400
0x0800
0x1000
Table 7.7: Zone Commands
Command Value
0x0200
0x0400
0x0800
0x1000
Holding Register
20001
Holding Register
Use Device/Module Holding Register
Address
Holding Register
Use Zone Holding Register Address
Modbus Communications
7.22
58