Installation And Configurations; The Ip Settings; To Connect With The Modbus Client - Honeywell HON-CGW-MBB Installation And User Manual

Installation and Configurations

7.14 Installation and Configurations
The CLSS Gateway can communicate with the Modbus client in an Ethernet LAN.

7.15 The IP Settings

The following information applies to IP settings:
• You can use only the eth1 port for connections to Modbus clients. For more details,
refer to 7.17 "To Configure the Modbus Settings"
• Each CLSS Gateway is shipped with a default node number of 235.
• The computer used to configure the CLSS Gateway must establish an IP connection
to the gateway. Consult with a network administrator if unsure how to make this
connection.
• Connecting more than one CLSS Gateway prior to reconfiguring the IP address will
result in an IP address conflict.

7.16 To Connect with the Modbus Client

1. At the CLSS Gateway side, connect an Ethernet cable to the Ethernet Port 1.
RED COLOR
BLACK COLOR
BROWN COLOR
GREEN COLOR
WHITE COLOR
2. At the Modbus client side, connect the other end of the Ethernet cable to the system
running the Modbus client.
CLSS Gateway - Installation and Users' Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022
Eth 1
(
Eth 0
(
Future Use
Future Use
P1
Future Use
P4
P7
P2
J5
.
CLSS
Cloud
Mobile
Connection
Ethernet
Connection
)
Modbus
)
Client
Configuration
Computer
/NUP
Fire Alarm Panel
Modbus Communications
53