3: Switches On The Gateway Board; Clss Gateway Parts - Honeywell HON-CGW-MBB Installation And User Manual

CLSS Gateway Parts

2.3.3 Switches on the Gateway Board
Below table informs about the switches on the gateway board. To locate the switches on
the gateway board, refer to
Switches
S6
S7
S8
Tamper
Switches
Tamper 1
Tamper 2
2.4 CLSS Gateway Parts
HON-CGW-MBB
CGW-MB
CGW-BB
50160636-001
32351718-001
CLSS Gateway - Installation and Users' Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022
Figure 2.1:, "Printed Circuit Board: Layout"
Table 2.3: Gateway Board Switches
For securely configuring the gateway's settings
Pressing the switch for six seconds switches the gateway board to the
configuration mode.
For changing the direction of the 24V power of the NUP/RS-232
connector
NUP_IN: The gateway board receives power through its NUP/RS-232
port.
NUP_OUT: The gateway board receives power through its power supply
port, which is connected to an external power supply source.
For enabling mobile pairing
Pressing the switch for ten seconds enables mobile pairing.
For alerting whenever the gateway enclosure door is opened
It is located at the front-side of the gateway, next to the LED indicators.
For alerting whenever the gateway board is removed from the enclosure
It is located at the backside of the gateway.
Part Number
Purpose
Purpose
Description
CLSS Gateway with enclosure
CLSS Gateway board
CLSS Gateway enclosure
CLSS Gateway kit. It includes a 30" NUP
cable and a NOTIFIER lock and key set.
10 ft NUP Serial (RS-232) cable kit
Overview
.
18