Table of Contents
Advertisement
How Do I...
Subtopic
Front door LED behavior
MFF Pro and Pro Plus
Finisher Unload Button
C or Z fold jobs rotated 180 degrees
PostScript Jog command
Dual Stapling with Mixed Sizes
See also
For an overview of more sophisticated jobs and workflows, see
For details about advanced features, see
14-44
The LED behavior on the Front door: The intent is to
provide to the customer feedback as to which stacker is
being used when 2 BFMs are attached. The states are:
Steady On: Stacker is In Use Blink: Ready to Unload
Steady Off: Not in use LED State Change: By selecting
the Unload button, the LED will change state. If it is off,
it will turn on for the duration that the button is de-
pressed. If it is on, it will turn off for the duration that
the button is depressed. This request can occur when an
unload is needed prior to the BFM finishing a set or the
machine is cycled down due to being out of paper and
needs to finish the set before the unload request is
honored.
You do not need to press the Finisher Unload Button to
remove output from the finisher. When you press the
Finisher Unload Button, the finisher cycles down. Press
the Finisher Unload Button again to re-enable marking.
If landscape C-fold or Z-fold jobs printed from print cli-
ents, or the SDDF LEF scan, are rotated 180 degrees,
select 180 degree rotation from the Advanced tab in
Print Drivers at the PC application or from the Image
Edit tab, Image Rotation, at the Copier/Printer user in-
terface.
The PostScript Jog command, when used within a job,
does not perform as described in the Adobe PostScript
specifications. Changes to the Jog value create subsets
to which the job or queue level finishing selections are
applied. For example, if a job specifies<</Jog 3>> set-
pagedevice on page 1 and <</Jog 0>>setpagedevice on
page 5, then pages 1 through 4 will be finished as a unit
and pages 5 through the end of the job will be finished
as a separate unit. This is the same behavior as other
Xerox production printers, such as the DocuTech 6180.
On a MFF system, if you are Dual stapling mixed sizes
(that are a mix of LEF and SEF) from the Copy pathway,
they will print and staple correctly. However, if you also
save the job and reprint it later, the job will Fault. The
Print pathway currently can not handle Dual stapling
with mixed sizes.
Setting Up Complex
Advanced Publishing
Features.
Hint/Tip Description
Jobs.
Xerox
User Guide and Training Aid (UGTA)
®
Nuvera
®
Advertisement
Table of Contents
