Table of Contents
Advertisement
Multifunction Finisher (MFF) Specifications
The Multifunction Finisher offers the basic publishing option on the Xerox Nuvera EA Production System.
It is the only finisher in the configuration and can not be followed by any other finishing devices. It
provides stacking and stapling capabilities as well as the ability to make booklets and trifold documents.
There are two MFF models available.
• The Professional is a finisher that provides high capacity collating, stacking and stapling. It also
allows the ability to make booklets and trifold documents. This model consists of a Top Tray for
collecting or purging sheets, a Main Tray and a Bottom (Booklet) Tray.
• The Pro Plus is the Professional model with added functionality provided in the Interface Module
area. The Interface Module contains a sheet insertion module as well as a hole punch module. The
post process insertion capability of the MFF Pro Plus can insert covers, preprinted tabs and colored
paper. The hole punch module offers either a 2 and 3 Hole Paper Punch or a 2 and 4 Hole Paper
Punch that allows you to punch 2, 3 or 4 holes in the printed document, depending on the paper
punch installed and the finishing hole punch option selected.
Using the MFF
Go to
Using the Multifunction Finisher
Specifications
Top Tray
Bottom/Booklet Tray
Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
(MFF)for information on how to use the MFF.
MFF Professional
250 sheets of 20 lb bond (75 gsm)
or equivalent
Output to the Top Tray is delivered
with Side-1 down and sets are not
offset. It can be set as a destination
tray for non-stapled jobs. Sheets less
than 7 inches in the process direction
or 8 inches in the cross-process direc-
tion will automatically go to the Top
Tray. The Top Tray also receives
sheets that are purged from the sys-
tem.
250 sheets of 20 lb bond (75 gsm)
or equivalent
Output to the Top Tray is delivered
with Side-1 down and sets are not
offset. It can be set as a destination
tray for non-stapled jobs. Sheets less
than 7 inches in the process direction
or 8 inches in the cross-process direc-
tion will automatically go to the Top
Tray. The Top Tray also receives
sheets that are purged from the sys-
tem.
Machine Specifications
MFF Pro Plus
Same
Does not accept hole punched finish-
ing output
21-11
Advertisement
Table of Contents
