Table of Contents
Advertisement
Machine Specifications
• The BFM Plus Top Tray with Direct Connect is comprised of the Bypass BFM with an Interface
Module that has Top Tray capabilities and is able to connect directly to a DFA-compliant finisher(s).
The DFA-compliant finishers are limited to devices that have an 860mm height, Center registration,
and a velocity of 1130mm/s.
Using the BFM
Go to
Using the Basic Finishing Module (BFM)
adjustments that affect the BFM.
Capacities
Stacker
• 3,000 sheets total capacity of 20 lb. (75-80 gsm) paper or equivalent.
• The stack limit can be set from the UI for each BFM independently.
• Stapled sets with <15 sheets are limited to 100 sets.
• It can staple up to 100 sheets of 8.5 x 11 inch or A4 LEF, and 8.5 x 14 inch or B4 SEF of 20 lb. (75-80
gsm). Portrait, landscape, and dual position stapling are available
• The Stacker is the output tray for receiving compiled stapled and unstapled sets as well as single
sheets. Output is normally delivered with side-1 down and sets can be offset.
• You can use a combination of 3 finishers maximum.
Top Tray
• 250 sheets of 20 lb. (75-80 gsm) paper or equivalent.
• Output to the Top Tray is delivered with Side-1 down and sets are not offset.
• It can be set as a destination tray for non-stapled jobs.
• Sheets less than 7 inches in the process direction or 8 inches in the cross-process direction will
automatically go to the Top Tray. The Top Tray also receives sheets that are purged from the system.
• Paper size greater than 18.5 inches in the process length will run to the top tray only.
Stapler
• The Basic Finishing Module has two internal pass-through 100 sheet up side down staplers. The
stapler devices have the ability to portrait, landscape or dual staple all paper sizes between 5.5"x8.5";
/ A5 and 12.6"x18.5 inches. Finished sets can be stacked internally to the lower stacker tray.
• These staplers have the capability of stapling 100 sheets of 20lb. (75-80 gsm) or equivalent substrates
(reduced stapled sheet capabilities can result based on substrate properties (i. e. thickness, density,
material, coating, etc.).
• If either of the Staplers runs out of staples see
Stapler
Jams.
• An alternate Staple Cartridge is available with 30 sheets of 20lb. (75-80 gsm) paper capacity.
Contacting Xerox
for information on ordering refills.
• Each Stapler Cartridge holds 5000 staples.
21-18
for information on how to use the BFM and all of the
Replacing Staples in the BFM
Contacting Xerox
for information on ordering refills.
or if it jams see
Clearing
Xerox
®
Nuvera
User Guide and Training Aid (UGTA)
®
Advertisement
Table of Contents
