Error Code List (8000 To 9000) - Mitsubishi MELSEC QS Series Programming Manual

9.1.8

Error code list (8000 to 9000)

The following shows the error messages from the error code 8000 to 9000, the contents and
causes of the errors, and the corrective actions for the errors.
Error
Error
Code
Message
(SD0)
INTERNAL
8000 REGISTER
ERROR
INTERNAL
8010
BUS ERROR
8020
CPU A & B
CAN'T BE
SYNCHRO-
8021
NIZED
INCORRECT
8031
FILE
INCORRECT
8032
FILE
SAFETY
OUTPUT
8050
VERIFY
ERROR
INCORRECT
8060
FIRMWARE
*1 The operating status of a CPU module in case of an error can be set in the "Operation settings during remote station error" of "Parameter". The default is set
to "Stop" (The LED indication changes according to the status).
*2 At occurrence of "F****", a USER LED lights up.
9-28
9.1 Error Code List
9.1.8 Error code list (8000 to 9000)
Common Individual
Information Information
(SD5 to 15) (SD16 to 26)
Error
–
information
Error
–
information
Error
–
information
Diagnostics file
–
information
Diagnostics file
–
information
Module No./
–
Station No.
Error
–
information
LED Status CPU
Operation
RUN ERROR
Status
Off Flicker Stop
Off Flicker Stop
Off Flicker Stop
Off Flicker Stop
Off Flicker Stop
Off On Stop
Off Flicker Stop
Diagnostic
Timing
At power ON/
At reset/When
an END
instruction
executed.
At power ON/
At reset/When
an END
instruction
executed.
Always
When an END
instruction
executed.
At power ON/
At reset
When an END
instruction
executed.
When an END
instruction
executed.
At power ON/
At reset/When
an END
instruction
executed.