Mitsubishi MELSEC QS Series Programming Manual page 133

Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and
the corresponding error code is stored into SD0.
• The device range of n-points from
Program Example
(1) The following program outputs the lower 4 bits of data at D66 to D69 to Y30 to Y3F in 4-point
units.
[Ladder Mode]
[Operation]
Before execution
(transfer source)
b15
D66
D67
D68
D69
Ignored
(2) The following program outputs the data at X20 to X2F to D100 to D103 in 4-point units.
[Ladder Mode]
[Operation]
Before execution
(transfer source)
or
S
After execution
(transfer destination)
b4 b3 b0
1 1 1 0 1 1
0 0 0 0 0 0
1 0 0 1 1 0
0 1 1 0 1 1
X2F X2C X2B X28 X27 X24 X23
1 0 0 0 0 1 1 1 0 1 1 0 0 1 0 0
6.4.3 Block 16-bit data transfers (BMOV(P))
exceeds the corresponding device range.
D
1 0 1 Y33-Y30
0 0 0 Y37-Y34
0 1 1 Y3B-Y38
1 0 1 Y3F-Y3C
X20
After execution
(transfer destination)
b15 b4 b3
0 0 0 0 0 0 0 0 0 0 0 0 0 1 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 1 1 0
0 0 0 0 0 0 0 0 0 0 0 0 0 1 1 1
0 0 0 0 0 0 0 0 0 0 0 0 1 0 0 0
Filled with 0
.
6.4 Data Transfer Instructions
BMOV(P)
(Error code: 4101)
b0
D100
D101
4 points
D102
D103
6-35
6