Mitsubishi MELSEC QS Series Programming Manual page 177

Hide thumbs Also See for MELSEC QS Series:
Table of Contents

Advertisement

Error
Code
Error Contents and Cause
(SD0)
• The number of modules actually
mounted is different from that is set in
Network parameter for CC-Link IE
controller network.
• The start I/O number of the module
actually mounted is different from that
is set in Network parameter for CC-
Link IE controller network.
• Some data in the parameters are not
supported.
• The station type for a CC-Link IE
controller network has been changed
while the power is ON.
(RESET RUN is required for
changing the station type.)
3100
• The number of modules actually
mounted is different from that is set in
Network parameter for MELSECNET/
H.
• The start I/O number of the module
actually mounted is different from that
is set in Network parameter for
MELSECNET/H.
• Some data in the parameters are not
supported.
• The station type for a MELSECNET/H
has been changed while the power is
ON. (RESET RUN is required for
changing the station type.)
• The mode switches of MELSECNET/
H module are out of the setting range.
*3 : MELSECNET/H modules whose serial number (first five digits) is "08102" or higher are targeted.
Corrective Action
• Check the setting in Network
parameter and actual mounting
status, and if they differ, correct either
the setting or mounting status so that
they become the same. If the
parameter setting is corrected, write
Network parameter to the CPU
module.
• If an error occurs even after
correction, a hardware failure is
considered. (Please consult your
local Mitsubishi representative.)
• Check the setting in Network
parameter and actual mounting
status, and if they differ, correct either
the setting or mounting status so that
they become the same. If the
parameter setting is corrected, write
Network parameter to the CPU
module.
• If an error occurs even after
correction, a hardware failure is
considered. (Please consult your
local Mitsubishi representative.)
• Set the mode switches of
MELSECNET/H module within the
setting range.
9.1 Error Code List
9.1.5 Error code list (3000 to 3999)
Corresponding
CPU
9
QS
9-17

Advertisement

Table of Contents
loading

Table of Contents