Table of Contents
Advertisement
OUT T, OUTH T
Program Example
(1) The following program turns Y10 and Y14 ON 10 seconds after X0 has gone ON.
[Ladder Mode]
*2: The set value of the low-speed timer indicates its default time limit (100 ms).
(2) The following program uses the BCD data at X10 to X1F as the timer's set value.
[Ladder Mode]
(3) The following program turns Y10 ON 250 m after X0 goes ON.
[Ladder Mode]
*3: The set value of the high speed timer indicates its default time limit (10 ms).
5.3 Output Instruction
5-22
5.3.2 Timers (OUT T,OUTH T)
*2
Converts BCD data at X10 to X1F to BIN
and stores the converted value in D10.
When X2 is turned ON, starts counting using
the data stored in D10 as the set value.
Y15 turns ON at the count up of T2.
*3
Advertisement
Table of Contents
