800/600 Line EFX® Assembly Guide Follow the steps in the order listed in this assembly guide. For more product Console information, visit us at www.precor.com. Moving arms WARNING At least two people are required to assemble the equipment. DO NOT attempt assembly by yourself.
Page 5
Tape them to the top of the console mount to secure them temporarily. IMPORTANT DO NOT stretch, crimp, or damage the cables. Cables damaged by improper installation are not covered by the Precor Limited Warranty.
Page 6
Route the power supply internally Depending on the site location and distance from an outlet, you might need to route the power supply either internally or externally. WARNING DO NOT allow cables to touch any moving parts around the lift motor body—lift screw, yoke, or ramp.
Page 7
Route the power supply externally WARNING DO NOT allow cables to touch any moving parts around the lift motor body—lift screw, yoke, or ramp. Run the ramp through its movement path a few times and have someone else watch to make sure no cables are caught up or hanging loosely.
Page 8
To install the side covers: For 800 EFX only: Press the side panels into place ensuring the latches under each panel are secured. For 800 EFX only: Lift up the lower frame cover about an inch from the frame. Notes for 800 EFX IMPORTANT Although there are two screw holes in the frame cover, DO NOT install these •...
Page 9
To install the lower panel and front cover: For all consoles: Attach the lower panel using two screws , and route the power cable through the slot. Fully tighten fasteners on the panel (see arrow Position the cover plate (packaged with hardware kit) into the center opening in Figure 11).
Page 10
To install the yoke cover and shelf: To attach the anchors: Attach the yoke cover to the back of the base mount using two screws Place an anchor on top of an arm frame and secure it using two screws (Figure 12).
Page 11
Install EFX arms To install moving arms: Place the inner cover between the link pairs and attach the link to the moving arm using a 9/16-inch socket wrench on the pre-installed bolts and tighten to Insert the shaft of the moving arm to the center mount (Figure 15) and 300 in-lb (33.90 N-m) of torque.
Page 12
Install fixed arms (800 EFX only): Install the console. For instructions, refer to the console guide included in the console box. Install two screws into the upper display (Figure 18). Insert the shaft of the arm to the center mount using two set screws Partially tighten mounting fasteners.
Page 13
To complete the installation: To attach the cup holder: Position the badge plate on the front cover and press into place. Position the cup holder on top of the lower shelf, making sure to catch the bottom latch in the shelf component. Figure 20 Wrap the rubber gasket on top of the badge plate from the back of the display mount so the split is pointed toward the front.