Precor C534i Service Manual page 7

The test name HARDWARE VALIDATION will scroll once across the display.
3.
The test name "DISPLAY" will be displayed. Press the OK key to enter the display test or an
4.
, key to proceed to a different test.
Each time you press the OK key a different block of LED's will illuminate. Check each LED
5.
in each block to ensure that all are functioning. As you move through the LED blocks, one
press of the OK key will cause all of the LED's to be off.
Press the CANCEL key to proceed to the keyboard test.
6.
The test name "KEYBOARD" will be displayed. Press the OK key to enter the keyboard test
7.
or an , key to proceed to a different test.
8. A graphical representation of all the keys on the keyboard will be displayed. When a key is
pressed the representation of the key on the display will be turned "off". Check all of the
keys on the keyboard in this manner.
Press and hold the CANCEL key for several seconds to proceed to the heart rate test.
9.
10. The test name "HEART RATE" will be displayed. Press the OK key to enter the heart rate
test or an , key to proceed to a different test.
11. Both the hand held heart rate and wireless heart rate function must be tested. A chest strap
heart rate transmitter or a heart rate test transmitter must be used to test the wireless heart
rate function.
12. When a heart rate signal is received, the unfiltered and filtered heart rates will be displayed.
In addition the Polar heart rate will be displayed in the "Heart Rate" window. The red heart
and the smart rate LED's will illuminate.
13. Press the CANCEL key to proceed to the brake test.
14. The test name "BRAKE" will be displayed. Press the OK key to enter the brake test or an ,
key to proceed to a different test.
15. Powerbits will be displayed in the upper window and the resistance level will be displayed in
the lower middle window. Pressing the resistance
power bits being applied to the eddy current system., ranging from 60 to 170 powerbits.
Because this is a self powered EFX, you must pedal fast enough to keep the EFX powered
up and the resistance up, otherwise the powerbits will bo below the selected setting.
Press the CANCEL key to proceed to the RPM test.
16.
17. The test name "RPM" will be displayed. Press the OK key to enter the RPM test or an
key to proceed to a different test.
18. The current RPM will be shown as "PULSE XX". The pulses are updated in real time and
will display the actual pulse count.
C534i Elliptical Fitness Crosstrainer
, keys will change the number of
,
Page 7