Installation - Precor C534i Service Manual

Diagram 7.4 - Bottom and Front Cover Sections
Front View
8. Remove the four screws that fasten the bottom cover section to the frame. Unsnap the front
cover section from the bottom cover section and remove the front and bottom cover
sections.

Installation

9. Set the bottom cover section in its mounting position and fasten it with the screws removed
in step 9
10. Snap the front cover in its mounting position on the bottom cover and fasten it with the
screws removed in step 8, torque the screws to 6-9 inch pounds. Set the lower PCA in its
mounting position and fasten it with the screws removed in step 7, torque the screws to 6-9
inch pounds. Re-install the cover on the lower PCA.
11. Set the wedge cover in its mounting position and fasten it with the screws removed in step
6., torque the screws to 6-9 inch pounds
12. Set the left and right cover sections in their mounting positions making sure that all of the
tabs on the left and right cover are correctly aligned in the bottom cover section.
13. Set the top cover in its mounting position, and press it into the two snaps shown in Diagram
7.2. Fasten the top cover section with the three screws removed in step 4. Torque the
screws to 6-9 inch pounds.
14. Place the access panel in its mounting position on the top cover and press it into place.
Front Cover
Section
Bottom Cover
Section
C534i Elliptical Fitness Crosstrainer
Rear View
Page 34