Precor C534i Service Manual page 10

14. The display name "METRICS BOARD SW PART NUMBER" will be displayed, press the
OK key, the metrics board software part number will be displayed.
15. Press the CANCEL key to proceed to the serial number display.
16. The display name "SERIAL NUMBER" will be displayed, press the OK key, the serial
number will be displayed. If the serial number is not installed, see Procedure 2.5 to upload
the serial number.
17. Press the CANCEL key to proceed to the usage log.
18. The display name "USAGE LOG" will be displayed, press the OK key.
19. The program used and the time the program was used will be displayed.
20. The keys , will scroll you through the list of programs that have been used.
21. Press the CANCEL key to proceed to the error log display
22. The display name "ERROR LOG" will be displayed press the OK key.
23. The first error log entry will be displayed (1: ERXX XX STRIDES XX HRS).
24. Pressing the ,
selected error. Entry 1 will be the most recent error log entry, with each succeeding entry
being older than the preceding entry.
25. If the error log is empty NO ERRORS will be displayed.
26. Pressing and holding the QUICK START key for 2 seconds will cause the prompt CLEAR?
to be displayed, holding the QUICK START for an additional 2 seconds will clear all existing
entries from the error log. The display will confirm that the error log has been cleared by
displaying OK. The display will revert to the first log entry and show it as a null entry (1: ---).
If the QUICK START key is not held for a minimum of 4 seconds, the error log will not be
cleared.
27. Press the RESET key to exit the diagnostics display program.
keys will move you through the log entries. Press the OK key to view the
C534i Elliptical Fitness Crosstrainer
Page 10