Figure 9 Attachment Of Front Mount Bracket To Front Rack Cabinet Posts; Figure 10 Adjustment Of Rail Length To Fit Rack Cabinet - Seagate Exos X 4006 Series Hardware Installation And Maintenance Manual

6. Hold the biased mount bracket in that position and barely tighten against the front rack post using an 8mm nut driver or a
Philips screwdriver.
7. Extend the length of the rail until fully mating the rear mount bracket pins in the mirror location on the rear rack post.
8. Verify that the rails are level at the same height on both rack posts, and that all mount bracket location pins fully seat in
identical locations in the rack posts.
9. Facing the rear of the rack cabinet, insert a Phillips-head M5 x 15 screw into the center hole of the rear mount bracket.

Figure 9 Attachment of front mount bracket to front rack cabinet posts

Figure 10 Adjustment of rail length to fit rack cabinet

Chapter 4 Installation of 2U enclosures
26