Figure 24 Alignment Between 5U Chassis And Rails, Minus Rear Components For Clarity - Seagate Exos X 4006 Series Hardware Installation And Maintenance Manual
Hide thumbs
Also See for Exos X 4006 Series:
- Getting started (2 pages) ,
- Getting started (2 pages) ,
- Getting started (2 pages)
Table of Contents
Advertisement
3. Complete the following actions to position the mechanical lift and the 5U chassis:
a. Using proper safety precautions, position the 5U chassis on the mechanical lift perpendicular to the lift wheels.
b. Move the mechanical lift into position perpendicular to the rack cabinet so that the storage enclosure is parallel to the
opening and is a minimum of 5 to 7 inches (12.7cm to 17.78cm) away from the rack cabinet.
c. Adjust the mechanical lift height to be as close as possible to the allocated 5U location.
d. Moving only the 5U chassis, position it so the chassis aligns with the outer rails in the rack.
Figure 24 Alignment between 5U chassis and rails, minus rear components for clarity
4. Complete the following actions to properly secure the 5U chassis on its rails:
a. Keep the 5U chassis stationary on the mechanical lift.
b. Conduct a visual inspection of both sides to verify the bottom of the storage enclosure chassis rests squarely on the
front of the bottom shelf of the outer rail and that the direction is straight in, not at an angle.
5. Complete the following actions to insert the 5U chassis into the rack cabinet:
a. Facing the front of the enclosure, carefully exert even pressure on both sides of the storage enclosure front, inserting
the storage enclosure until the rack ear flanges are flush with the front rack posts.
b. Carefully lower the mechanical lift.
c. Thoroughly examine the rack rails for issues such as bowing, scraping, resistance, or indicators of misalignment.
6. Complete the following actions to secure the 5U chassis:
a. Thread a lock washer and then a washer onto each of 2 Panhead 10-32 screws.
b. Facing the front of the enclosure, insert a Panhead 10-32 screw with washers into the top and bottom holes in the
operator's (ops) panel, then hand tighten firmly against front rack post with a Phillips screwdriver.
41 Chapter 5 Installation of 5U enclosures
Advertisement
Table of Contents
