Seagate Exos X 4006 Series Hardware Installation And Maintenance Manual page 67

Table 11 Factory default network port IP addresses (continued)
IP version Controller 0A addresses
Autoconfig:
Gateway:
IPv6
Link-Local Address: fe80::2c0:ffff:fe44:952f
Autoconfig IP:
To connect to a controller module for configuration:
1. Connect a serial cable from your management host to the CLI port on one of the CMs.
2. Launch the terminal emulator software and enable the CLI port for subsequent communication.
3. Press Enter to access the CLI prompt.
4. At the prompt, login with setup, press Enter, then press Enter again at the password prompt, for example:
System Version: S100R009
OS Version: SPM100R009-01
MC Version: SXM100R009-01
Serial Number: 00C0FF535A86
SEAGATE00C0FF527EB8B login: setup
Password:
5. For first time access to the SMC, enter Y at the prompt to continue.
6. To log in at the prompt, choose from one of the following actions:
a. For first time access, create a user, such as manage, and follow the on-screen directions to create a user account. After
doing so, the session will expire, and you can log in as the user you just created.
b. For all subsequent log in activity, log in using valid system user credentials.
7. At the prompt, type the following command to set the IP address for each controller module or both controller modules:
set network-parameters ip <address> netmask <netmask> gateway <gateway> controller a|b
where:
<address> is the IP address of the controller
<netmask> is the subnet mask
<gateway> is the IP address of the subnet router
a|b specifies the controller whose network parameters you are setting
For an ipV4 static example:
# set network-parameters ip 192.168.0.10 netmask 255.255.255.0 gateway 192.168.0.1 controller a
# set network-parameters ip 192.168.0.11 netmask 255.255.255.0 gateway 192.168.0.1 controller b
For a DHCP example:
# set network-parameters dhcp controller a
# set network-parameters dhcp controller b
NOTE See the CLI Reference Guide for information about IPv6, and the commands used to add IPv6 addresses and set
IPv6 network parameters. The ipv6 term is included within each relevant command name.
67 Chapter 8 Storage enclosure management
Enabled Autoconfig:
:: Gateway:
Link-Local Address: fe80::2c0:ffff:fe44:7010
6::2c0:ffff:fe44:952f Autoconfig IP:
Controller 0B addresses
Enabled
::
6::2c0:ffff:fe44:7017