Figure 29 Release Latch Properly Locked; Figure 30 Safety Lock To Release Left Drawer Slide Rail (Lower Drawer Used For Relational Clarity) - Seagate Exos X 4006 Series Hardware Installation And Maintenance Manual

c. Push the DDIC down until the top is flush with the top of the slot.
d. While holding it against the bottom of the slot, slide the top latch toward the rear of the drawer until it locks into place
and the DDIC release latch locks.
Figure 28 Release latch open and unlocked
e. Select the next DDIC, orient it so the LED is towards the drawer front, and insert into the next slot in the same manner.
f. Repeat, moving to the next slot in the sequence, until you complete the row.
g. Populate the next two rows in sequence.
h. Verify that all drives are at the same level and all DDIC release latches are properly locked.
CAUTION Do not proceed to close the drawer unless all DDICs are in a fully locked position or DDIC height can
inhibit or completely prevent drawer access once you close it.
3. Complete the following actions to close a drawer:
a. Press and hold the safety lock latches with the blue touchpoint at the front of both extended drawer slide rails.

Figure 30 Safety lock to release left drawer slide rail (lower drawer used for relational clarity)

b. Pressing simultaneously inward, begin sliding the drawer back into place until the safety lock clears the opening.
c. Placing the heels of both palms against the face of the drawer near the anti-tamper locks, exert even inward pressure
until the drawer is almost flush with the rack ear flanges.
d. Simultaneously press inward and hold both drawer pull handles as you push Drawer 1 closed until it fully latches.
4. Open the lower drawer and repeat the above DDIC installation process.

Figure 29 Release latch properly locked

Chapter 5 Installation of 5U enclosures
44