Rear Panel - Yamaha DTXPRESS IV Owner's Manual

Rear Panel

!2
!2 MIDI OUT jack
For sending data from the DTXPRESS IV to an external MIDI
device. With this jack, you can use the DTXPRESS IV as a con-
trol device to trigger voices from an external tone generator, or
synchronize song playback or the click of the DTXPRESS IV
with the playback of an external sequencer. (p. 13)
!3 Trigger Input jacks (1SNARE thru 8KICK/9)
For connecting pads or drum triggers (Yamaha DT20, etc.) to
receive trigger signals.
Connect external pads such as a snare, tom, etc., according to the
indication below each input. (p. 10, 11)
1SNARE ..................... Compatible with three-zone pads and the pad
controller.
2TOM1/10, 3TOM2/11, 4TOM3/12, 8KICK/9
.............................. Mono x 2 inputs
A parallel cable (stereo plug—mono jack x 2;
refer to the illustration below) connected to
this jack lets you connect two mono pads to the
jack. Also, if the KP65 kick pad is connected
to this jack with a stereo cable, the external pad
input jack on the KP65 can be used as the input
for input jacks 9, 10, 11, or 12.
5RIDE, 6CRASH ..... Compatible with three-zone pads.
7HI HAT ..................... Compatible with stereo pads (with switches)
G Parallel cable
Stereo phone plug
!4 Hi-hat controller jack (HI HAT CONTROL)
For connecting a hi-hat controller. (p. 10, 11)
* Use a cable with a stereo plug (shown below) when connect-
ing a hi-hat controller.
Double insulator
!3 !5
!5 Output jacks (OUTPUT L/MONO, R)
For connecting the DTXPRESS IV to an external amplifier, mixer,
etc.
For mono playback use the L/MONO jack. For stereo playback
connect both L and R jacks. (p. 12)
!6 Headphones jack (PHONES)
Connect a set of stereo headphones to this jack to monitor the
DTXPRESS IV. (p. 12)
!7 AUX IN jack
Connect the output of an external audio device, etc., to this jack
(stereo mini jack). (p. 13)
This is convenient for playing along with music from a CD
player, etc.
* Use the volume control on the external device to adjust the
volume balance.
!8 Master Volume (VOLUME)
Adjusts the DTXPRESS IV's overall volume (output level of the
signal sent via the OUTPUT jacks and PHONES jack). Rotate the
knob clockwise to increase the volume, or counter-clockwise to
decrease it.
!9 Power supply jack (DC IN 12V)
Connect the supplied AC power adaptor to this jack. To prevent
the adaptor from becoming unplugged, secure the cable to the
Mono phone jack
cable clip.
@0 Cable clip
Prevents the power cord from accidentally becoming unplugged.
Mono phone jack
(p. 12)
@1 POWER Switch
The power is turned on when the button is set to this position:
(>). The power is off when set this way: (?).
Controls and Functions
!6 !7 !8
!4 !9 @0
IV
DTXPRESS
@1
9
Owner's Manual