Setting Ascend Radius Parameters For A User - Cisco Servers User Manual

Chapter 7 Setting Up and Managing User Accounts
Step 1
Step 2
Step 3
Step 4

Setting Ascend RADIUS Parameters for a User

78-13751-01, Version 3.0
To configure and enable Cisco IOS RADIUS attributes to be applied as an
authorization for the current user, follow these steps:
Perform Steps 1 through 3 of the
page 7-5.
Result: The User Setup Edit page opens. The username being added or edited
appears at the top of the page.
Before configuring Cisco IOS RADIUS attributes, be sure your IETF RADIUS
attributes are configured properly. For more information about setting IETF
RADIUS attributes, see the
section on page 7-37.
In the Cisco IOS/PIX RADIUS Attributes table, to specify the attributes to be
authorized for the user, follow these steps:
a. Select the [009\001] cisco-av-pair attribute check box.
Type the commands (such as TACACS+ commands) to be packed as a
b.
RADIUS VSA.
Continue to select and define attributes, as applicable.
c.
Do one of the following:
If you are finished configuring the user account options, click Submit to
a.
record the options.
To continue to specify the user account options, perform other procedures in
b.
this chapter, as applicable.
The Ascend RADIUS parameters appear only if all the following are true:
A AAA client has been configured to use RADIUS (Ascend) in Network
•
Configuration.
The Per-user TACACS+/RADIUS Attributes check box is selected under
•
Advanced Options in the Interface Configuration section.
User-level RADIUS (Ascend) attributes you intend to apply have been
•
enabled under RADIUS (Ascend) in the Interface Configuration section.
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
Advanced User Authentication Settings
"Adding a Basic User Account" section on
"Setting IETF RADIUS Parameters for a User"
7-39