Cisco Servers User Manual page 220

Basic User Setup Options
b.
c.
To view the server details of the shared NARs you have selected to apply, you
Tip
can click either View IP NAR or View CLID/DNIS NAR, as applicable.
Step 3 To define and apply a NAR, for this particular user, that permits or denies this user
access based on IP address, or IP address and port, follow these steps:
You should define most NARs from within the Shared Components section so
Tip
that they can be applied to more than one group or user. For more information,
see the
page
a.
b.
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
7-14
To specify whether one or all shared NARs must apply for the user to be
permitted access, select one of the following two options, as applicable:
All selected NARS result in permit
•
Any one selected NAR results in permit
•
Select a shared NAR name in the NARs list, and then click —> (right arrow
button) to move the name into the Selected NARs list.
"Shared Network Access Restrictions Configuration" section on
5-7.
In the Network Access Restrictions table, under Per User Defined Network
Access Restrictions, select the Define IP-based access restrictions check
box.
To specify whether the subsequent listing specifies permitted or denied IP
addresses, from the Table Defines list, select one of the following:
Permitted Calling/Point of Access Locations
•
• Denied Calling/Point of Access Locations
Chapter 7 Setting Up and Managing User Accounts
78-13751-01, Version 3.0