Configuring Nortel Radius Settings For A User Group - Cisco Servers User Manual

Configuration-specific User Group Settings
Step 5
Step 6
Step 7

Configuring Nortel RADIUS Settings for a User Group

Note
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
6-42
In the Microsoft RADIUS Attributes table, specify the attributes to be authorized
for the group by selecting the check box next to the attribute. Where applicable,
further define the authorization for that attribute in the field next to it. For more
information about attributes, see
documentation for network devices using RADIUS.
Note The MS-CHAP-MPPE-Keys attribute value is generated by
Cisco Secure ACS; there is no value to set in the HTML interface.
To save the group settings you have just made, click Submit.
For more information, see the
on page 6-50.
To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
The Nortel RADIUS attribute configurations appear only when both the following
are true:
A network device has been configured in Network Configuration that uses a
•
RADIUS protocol that supports the Nortel RADIUS VSA.
Group-level Nortel RADIUS attributes have been enabled on the RADIUS
•
(Nortel) page of the Interface Configuration section.
Nortel RADIUS represents only the Nortel VSA. You must configure both the
IETF RADIUS and Nortel RADIUS attributes.
To hide or display Nortel RADIUS attributes, see the
Configuration Options for RADIUS (Nortel)" section on page
Chapter 6 Setting Up and Managing User Groups
Appendix D, "RADIUS Attributes,"
"Saving Changes to User Group Settings" section
or the
"Setting Protocol
3-18.
78-13751-01, Version 3.0