Assigning A User To A Client Ip Address - Cisco Servers User Manual

Chapter 7 Setting Up and Managing User Accounts
Step 3

Assigning a User to a Client IP Address

Step 1
Step 2
78-13751-01, Version 3.0
Do one of the following:
If you are finished configuring the user account options, click Submit to
a.
record the options.
To continue to specify the user account options, perform other procedures in
b.
this chapter, as applicable.
To assign a user to a client IP address, follow these steps:
Perform Steps 1 through 3 of the
page 7-5.
Result: The User Setup Edit page opens. The username being added or edited
appears at the top of the page.
Under Client IP Address Assignment in the User Setup table, select the applicable
option. Choices include the following:
Note The IP address assignment in User Setup overrides the IP address
assignment in Group Setup.
Use group settings—Select this option to use the IP address group
•
assignment.
No IP address assignment—Select this option to override the group setting
•
if you do not want an IP address returned by the client.
Assigned by dialup client—Select this option to use the IP address dialup
•
client assignment.
Assign static IP address—Select this option and type the IP address in the
•
box, if a specific IP address should be used for this user.
Note If the IP address is being assigned from a pool of IP addresses or
by the dialup client, leave the Assign IP address box blank.
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
"Adding a Basic User Account" section on
Basic User Setup Options
7-11