Flash - NEC Xen Topaz Features And Specifications Manual

XEN Topaz

Flash

• Description
Flash allows an extension user to access certain CO and PBX features by interrupting
trunk loop current. Flash lets an extension user take full advantage of whatever
features the connected telco or PBX offers. You must set the Flash parameters for
compatibility with the connected telco or PBX.
Conditions
None.
Default Setting
Enabled.
• Programming
• Related Features
Features and Specifications Manual
14-02-03: Analogue Trunk Data Setup – Flashing
Make sure this item is set for open loop Flash (0).
14-02-04: Analogue Trunk Data Setup - Flash for Timed Flash or Disconnect
For each trunk, indicate if Flash is for Flash (0) or open loop disconnect
(1).
15-02-05: System Telephone Basic Data Setup - Transfer Key Operation
Mode
If CONF (TRF) key should access Flash, enter 2. Otherwise, enter 0 or
1.
15-03-04: Single Line Telephone Basic Data Setup – Flashing
In a single line telephone's Class of Service, enable (1) or disable (0) the
ability to hookflash for system feature access.
20-06-01: Class of Service for Extensions
Assign a Class Of Service (1-15) to an extension.
81-01-14: Analogue Trunk Initial Data Setup - Hookflash 1
Set the Flash duration (16-4080mS) for analogue trunk circuits.
81-01-15: Analogue Trunk Initial Data Setup - Hookflash 2
Set the open loop disconnect duration (16-4080mS) for analogue trunk
circuits.
• PBX Compatibility
If the system is behind a PBX, Flash normally gives the extension user access to
many PBX
features.
• Toll Restriction
The system applies Toll Restriction (if applicable) to the number a user dials after
flashing a trunk.
• Voice Mail Integration
NEC Business Solutions Ltd
Chapter 4 - 171