Installing The Clutch Discs - Husqvarna FC 450 2014 Repair Manual

17 ENGINE

Installing the clutch discs

17.5.16
-
Slide the outer clutch hub
Turn oil pump gear wheel
0
-
Slide on washer and inner clutch hub (D.
-
Position the new lock washer and mount nut @. Tighten the nut, holding the
inner clutch hub with a special tool.
Guideline
I
Nut, inner clutch hub
I
Clutch holder (51129003000) (
-
Secure the nut with the lock washer.
-
Lock the outer clutch hub and primary gear using special tool (;).
I
Gear segment (80029004000) (
@).
-
Mount and tighten nut
Guideline
Nut, primary gear
-
Set the crankshaft to top dead center and lock it with special tool Gi).
I
Locking screw (113080802) (
-
Thoroughly oil the clutch facing discs.
-
Beginning with an intermediate clutch disc, alternately insert all other clutch fac-
ing discs and intermediate clutch discs into the outer clutch hub.
O.
Mount pressure piece
(D
onto the gearbox main shaft.
8
until the gear teeth of the clutch basket engage.
I
M18x1.5
p. 221)
.-
p. 226)
.-
M20LHx1 .5 100 Nm
(73.8 lbf ft)
p. 219)
.-
174
I 80 Nm (59 lbf ft)
Loctite 648
® ™