Engine Assembly; Installing The Crankshaft; Installing The Transmission Shafts; Installing The Shift Forks - Husqvarna FC 450 2014 Repair Manual

17 ENGINE
17.5
Engine assembl
17.5.1

Installing the crankshaft

17.5.2

Installing the transmission shafts

17.5.3

Installing the shift forks

0-
-
Tighten the right section of the engine case in the engine assembly stand.
-
Heat the crankshaft bearing.
I
Guideline
so c
(176 °F)
0
Info
•
I
Do not damage the seal ring.
-
Mount the special tool on the clutch end of the crankshaft.
I
Mounting sleeve (78029005100) (� p. 225)
-
Push the crankshaft all the way into the bearing seat of the right section of the
engine case.
-
Remove the special tool.
-
Lubricate all bearings.
-
Slide both transmission shafts into the bearing seats.
Info
Make sure not to misplace the washers.
O.
-
Mount lock ring
-
Lubricate all parts thoroughly.
O
-
Mount shift fork in the upper shift groove of the main shaft.
-
Mount shift fork @ in the lower shift groove of the countershaft.
8
-
Mount shift fork in the upper shift groove of the countershaft.
C,.
-
Mount shift rollers
• Info
I
Fix the shift rollers in the shift forks with grease.
169