6
FORK, TRIPLE CLAMP
=
�
6.20
Changing the Rilot bushing
-
Measure the run-out of the inner tube.
I
Inner tube run-out
If the measured value is greater than the specified value:
-
200685-10
-
Measure the inside diameter of the outer tube at several locations.
I
Inside diameter of the outer tube
If the measured value is greater than the specified value:
-
-
Check the outer tube for damage.
If there is damage:
-
-
Check the surface of the sliding bushing.
If the bronze-colored layer
face is rough:
-
e
200665-10
-
Check the spring length.
I
Guideline
Spring length with preload spacer(s)
If the measured value is greater than the specified value:
-
If the measured value is less than the specified value:
-
200666-10
Preparatory work
-
Disassemble the fork legs. (,... p. 16)
-
Disassemble the cartridge. (,... p. 19)
-
Disassemble the piston rod. (,... p. 21)
-
Disassemble the screw sleeve. (,... p. 23)
Main work
-
Press the pilot bushing out of screw sleeve
I
Mounting tool (T14022) (,... p. 231)
200863-10
Change the inner tube.
Change the outer tube.
Change the outer tube.
f)
under the sliding layer G) is visible or the sur
Replace the sliding bushing.
Reduce the thickness of the preload spacers.
Increase the thickness of the preload spacers.
I
$ 0.20 mm ($ 0.0079 in)
I
$ 49.20 mm ($ 1.937 in)
I
490 mm (19.29 in)
O
using the special tool.
26