Disassembling The Screw Cap With The Membrane Holder - Husqvarna FC 450 2014 Repair Manual

6
FORK, TRIPLE CLAMP
Disassemblin the screw ca with the membrane holder
Info
The steps are identical for both fork legs.
-
Remove tap rebound
-
Remove spring
-
Remove the valve with the spring from tap rebound
-
Remove the 0-rings.
200862-10
Preparatory work
-
Disassemble the fork legs. (,... p. 16)
-
Disassemble the cartridge. (,... p. 19)
Main work
-
Clamp the screw cap with the membrane holder and the special tool into a vise.
Guideline
I
Use soft jaws.
I
Pin wrench (T103) (
• Info
I
Only tighten the vise lightly.
-
Remove compression holder
-
Remove membrane@}. Unclamp the special tool.
-
Remove 0-ring
-
Clamp the open end wrench in a vise. Position compression holder
-
Remove nut
-
Remove spring
fD.
@)
with the sleeve.
p. 227)
,...
Q.
8.
C,.
0.
22
fD.
O.