Husqvarna FC 450 2014 Repair Manual page 34

6
FORK, TRIPLE CLAMP
Info
Always change the dust boot, seal ring, lock ring and support ring.
Mount the sealing lip with the spring expander facing downward.
-
Slide on lock ring
-
Lubricate and slide on seal ring
I
Lubricant (T511) (
✓ Mount with the sealing lip facing downward the open side facing upward.
-
Slide on support ring
-
Remove the special tool.
-
Roughen, clean and lubricate the edges of the sliding bushings using 600 grit
sandpaper.
I
Fork oil (SAE 4) (48601166S1) (
200670-10
-
Slide on lower sliding bushing Ci).
-
Mount upper sliding bushing C).
Info
Gently pull them apart without using a tool.
-
Slide on the outer tube.
-
Warm up the outer tube in area
Guideline
1
so c
(122 °F)
0
-
Hold the lower sliding bushing with the longer shoulder of the special tool.
I
Mounting tool (T14040S) (
-
Press the outer tube all the way in.
-
Position the support ring.
-
Hold the seal ring with the shorter shoulder of the special tool.
I
Mounting tool (T14040S) (
-
Press the outer tube all the way in.
-
Mount lock ring
Info
The lock ring must audibly lock into place.
8.
CD.
p. 217)
r
C,.
r p. 216)
f)
of the lower sliding bushing.
r p. 232)
r p. 232)
8.
32