Scheduled Maintenance Inspection Report - Annual - Genie Z Series Maintenance Manual

Model
Serial number
Inspected by (print)
Inspection Type Legend
A = annual inspections
If any inspection receives an "N," tag and remove the machine from service, repair and re-inspect it. After repair, place a "R" in the box.
Confirm all applicable quarterly maintenance procedures
have been included and completed with the annual
inspection.
Drive Chassis
Extendable Axle Wear Pads (if equipped)
Check Drive Hub Oil Level and Fastener Torque
Turntable Mechanicals and Hydraulics
Grease the Turntable Rotation Bearing
Check Turntable Bearing Bolts
Inspect for Turntable Bearing Wear
Boom(s) and Platform
Jib Rotate Bearing (if equipped)
Grease the Platform Overload Mechanism
Test Platform Overload - All Models, Except ALC1000 and
S-60HC Models
Test Platform Overload - (ALC1000 models)
Test Platform Overload - (S-60 HC models)
Test Dual Capacity / Overload - SX-105XC, SX-125XC,
SX-135 XC
Test Dual Capacity / Overload - Z-45XC
Test Dual Capacity / Overload - S80XC, S-85XC
Inspect Boom Cables - All S-60, S-80 Models
Inspect Boom Cables - S-100 to S-125, S-100HD,
S-120HD, SX105XC, SX-125XC
Inspect Boom Cables - SX-135XC, SX-150, SX-180
Functions and Controls
Test the Bypass/Recovery Key Switch
Part No. 1268489GT
Scheduled - Annual
Maintenance Inspection Report - booms
Hour meter
Inspector company
Inspector signature
Y = yes, acceptable N = no, remove from service
R = repaired
∅ = not applicable
A-4
A-14
A-1
A-2
A-3
A-5
A-7
A-8
A-9
A-10
A-15
A-16
A-17
A-11
A-12
A-13
A-6
S ® Booms • Z ®
Make copies of this report to use for each inspection.
Select the appropriate procedures for the type of
inspection(s) to perform.

Booms Maintenance Manual
April 2018
Date
Machine owner
35