Genie Z Series Maintenance Manual page 5

April 2018
Revision History
Revision Date
A 9/2015
A1 10/2015
A2 11/2015
A3 11/2015
A4 12/2015
A5 1/2016
B 3/2016
B1 4/2016
B2 6/2016
B3 9/2016
C 11/2016
C1 12/2016
D 2/2017
Reference Examples:
Section – Specifications
Section – Maintenance, (procedure)
Part No. 1268489GT
Section
Quarterly
Specifications
Introduction
Quarterly
Specifications
All Sections
Specifications
Quarterly
Annual
Specifications
Introduction
All Sections
Quarterly
Quarterly
Annual
Programmed
S ® Booms • Z
Procedure / Description
Initial Release
Q-27 Test the Primary Angle Sensor
Hydraulic and Drive Hub Capacities
Updated Z-80/60 serial number for models included
Q-17 Inspect the Calibration Decal
Performance Spec. Z62
Add Z-60 DC/FE
Add Kubota D1105-E4B, GM .998L, GM 3.0L.
Update Deutz D2.9 L4 and Perkins 404F engine rpm's.
Q-7 Check the Generator Belts, Pulleys and voltage -
Bi-Energy Models
A-3 Inspect for Turntable Bearing Wear
Tires and Wheels, add Z60 DC/FE
Models Included
Add SX-135 XC
Q-26 Test the Secondary Boom Angle Sensor
Q-36 Inspect and Adjust Boom Cables
A-3 Inspect Turntable Bearing Wear
A-11, A-12, A-13 Inspect Boom Cables
P12-2 Replace Boom Cables
P12-3 Remove and Inspect Boom Cables
Electronic Version
Click on any content or procedure in the Table of Contents to view
® Booms
Maintenance Manual
Introduction
the update.
v