Genie Z Series Maintenance Manual page 175

April 2018
4 Inspect the cable diameter. Measure the
diameter in multiple locations along the cable.
Note: Calipers will be required to perform this
procedure.
correct
Cable Diameter Specifications
Model
S-60,S-65, S-60X, S-60XC, S-80, S-85 and S-80X
Extend
Retract
S-80XC and S-85XC
Extend
Retract
S-100 / 105 / 120 / 125 and SX-125 XC
Extend
Retract
SX-135 XC
Extend
Retract
Part No. 1268489GT
Programmed Maintenance Procedures
incorrect
Nominal Minimum
Diameter Diameter
.438 inches .416 inches
11.13 mm 10.5 mm
.438 inches .416 inches
11.13 mm 10.5 mm
.50 inches .475 inches
12.7 mm 12 mm
.438 inches .416 inches
11.13 mm 10.5 mm
.625 inches .594 inches
15.875 mm 15 mm
.375 inches .357 inches
9.5 mm 9 mm
.625 inches .594 inches
15.875 mm 15 mm
.50 inches .475 inches
12.7 mm 12 mm
S ® Booms • Z
SX-150 and SX-180
Extend - Boom 3
Retract - Boom 3
Extend - Boom 4
Retract - Boom 4
Note: If any section of the cable is below the
minimum diameter, the cables must be replaced as
a set.
® Booms
Maintenance Manual
.625 inches .594 inches
15.875 mm 15 mm
.625 inches .594 inches
15.875 mm 15 mm
.50 inches .475 inches
12.7 mm 12 mm
.50 inches .475 inches
12.7 mm 12 mm
163