Genie Z Series Maintenance Manual page 104

Maintenance Manual
Quarterly Maintenance Procedures
62 Activate the function enable/high RPM button
and attempt to raise the boom.
Result: The boom should not raise to more
than 11°.
Result: If the boom continues to raise, the
LSAX1ES or LSAX2ES switch are out of
adjustment or the wiring circuit is faulty and
will need to be replaced or repaired.
Bodily injury hazard. If the boom
raises to more than 11°, stop
immediately and lower the boom
until the boom is less than 11°.
See Repair Section. Failure to
retract the boom could result in
death or serious injury.
63 Remove the wire jumper installed in step 59
and connect the Deutsch connector to
LSAX1ES.
64 Disconnect the circle-end axle extend safety
switch LSAX2ES and install a wire jumper
between pin 3 and pin 4 of the Deutsch
connector.
65 Activate the function enable/high RPM button
and attempt to extend the boom.
Result: The boom should not extend to more
than 3 feet / 0.9 m.
Result: If the boom extends to more than 3
feet / 0.9 m, the LSAX1ES or LSAX2ES switch
are out of adjustment or the wiring circuit is
faulty and will need to be replaced or repaired.
Bodily injury hazard. If the boom
extends to more than 3 feet/ 0.9
m, stop immediately and retract
the boom until the boom is
extended to less than 2 feet/ 0.6
m. Failure to retract the boom
could result in death or serious
injury.
92
66 Activate the function enable/high RPM button
and attempt to raise the boom.
Result: The boom should not raise to more
than 11°.
Result: If the boom continues to raise, the
LSAX1ES or LSAX2ES switch are out of
adjustment or the wiring circuit is faulty and
will need to be replaced or repaired.
67 Remove the wire lumper installed in step 64
and connect the Deutsch connector to
LSAX2ES.
S ® Booms • Z ® Booms
Bodily injury hazard. If the boom
raises to more than 11°, stop
immediately and lower the boom
until the boom is less than 11°.
Failure to lower the boom could
result in death or serious injury.
Part No. 1268489GT
April 2018