Specifications Of Lighting Up / Blinking Leds - Iwatsu SS-500 Series Instruction Manual

Specifications of Lighting Up / Blinking LEDs

1.4 Specifications of Lighting Up / Blinking LEDs
Automatic
zero-
adjustment
−
1
2 Not performed
In execution
3
(Incl. demag.)
In execution
4
(excl. demag.)
5 Completed
6 Completed
7 Not performed Exceeds prescribed level
8 Completed
9 Completed
10 Not performed
11 Not performed Exceeds prescribed level
−
12
−
13
−
14
*1. When the
following conditions (p. 9 1):
• The upper jaw is unlocked.
• An overload has been detected whether or not the upper jaw is locked
in place.
• A current exceeding 0.5 A rms has been detected whether or not the
upper jaw is locked in place.
*2. Press any key to restore the device. The ranges cannot be switched until
the device is restored.
See "When the device has entered protection mode" (p. 6 2).
22
Device state
Overload
−
Not detected
−
−
Not detected
Exceeds prescribed level
Not detected
Exceeds prescribed level
Not detected
*1
−
−
DEMAG / AUTO ZERO
: Lighting up
Others
(On start-up)
(Initial state)
(No range keys available)
(No range keys available)
(Before use, normal state )
−
−
Upper jaw unlocked
Upper jaw unlocked
Upper jaw unlocked
Upper jaw unlocked
*1
Excess heat detected in
junction box*
ROM checksum error at
power-on (CPU failure)
key is pressed under any one of the

: Off : Blinking
LED
Green
POWER
2
Rapidly