Preparing For Measurement - Iwatsu SS-500 Series Instruction Manual

Preparing for Measurement

2.2 Preparing for Measurement



28
Turn off all equipment before connecting the
device.
Failure to do so can cause electric shock or a short-
circuit.
Before connecting the power cord to the inlet
on the rear panel of the PS-54 Power Supply,
verify that the supply voltage you plan to use
falls within the supply voltage range noted on
the PS-54.
Supplying a voltage that falls outside the specified
range to the PS-54 could damage the SS-530/SS-531 or
the PS-54, causing bodily injury.
Always operate the opening lever to retract,
extend, and lock the upper jaw.
If you retract, extend, or lock the upper jaw directly by
hand, the sensor may be damaged.
WARNING
CAUTION
NOTICE